Gauge Cluster Wiring Diagram
So I am wiring my monster miata up to my NB maita and trying to get the gauge cluster wired up does anyone know what pins are what for the NB cluster? Or have a diagram. Thanks.
|
copied from BarbyCar in the LED gauge cluster thread....
Here is the pinout for the 2000 if that helps. They are in the wiring diagram section C-a and C-b but for those without diagrams, here they are: There are three connectors 1, 2 and 3. From the driver's seat 1 is on the left, 3 in the middle and 2 on the right. Each connector pinout starts at "a" and the blue circuit is labelled with an appropriately placed "a". 1a= BR/B - Fuel System (ECU and fuel gauge sender) 1b= BR/Y - Cruise Light (from cruise module) 1c= B/Y +12v Switched (from meter fuse) 1d= No wire or P/B - If applicable, ABS light (from ABS module) 1e= No wire or R/W - If applicable, Automatic O/D light (from transmission control module) 1f= L/R +12v Unswitched from Room fuse 1g= Not used 1h= W - DRL module (high beam light) - No wire if no DRL 1i= R/Y - Headlight relay (via LH headlight fuse) - note R if no DRL 1j= not used 1k= not used 1L= W/R - Door switch (interior lights) 1m= Y - Speed sensor for manual. No wire for automatic 1n= B/L - Ground 1o= not used 1p= V - Start signal - from ign switch on manual. B/R from transmission control module if auto 2a= V/W - Water temp (from temp sensor) 2b= L/W Seat belt (seat belt switch - driver's side reel) 2c thru 2j not used 2k= G/O - ECU (and data link connector - also transmission control module if auto) 2L= W/B - ECU and cruise control module 2m= O - Speed sensor for manual. B/W from transmission control module for auto 2n= not used - goes to empty lamp socket 2o= W/L - ECU - controls CEL 2p= not used 3a= G/B - Left turn signal 3b= BR/R - ECU 3c= L/Y - Brake fluid light (and DRL control module. If no DRL then also to parking brake switch) 3d= BR - Air Bag module (and data link connector) 3e= Y/R - Oil Pressure "gauge" switch 3f= L/O - Key reminder switch 3g= R/B - Instrument lights +12v from TNS relay 3h= GY/R - Instrument lights dimmer control to ground 3i= G/W - Right turn signal 3j= B - Ground (connects internally in cluster to high beam light if no DRL) L=Blue, B=Black, BR=Brown, G=Green, GY=Grey, O=Orange, R=Red, W=White, Y=Yellow & V=Violet |
thanks so much think that will help.
|
I need a 99 the 00 is diffrent
|
Originally Posted by six
(Post 4298)
I need a 99 the 00 is diffrent
|
I've got one of these at the house. They are a good investment as a Miata owner.
I would scan the info but I'm not where it is. |
All times are GMT -5. The time now is 10:14 AM. |
© 2024 MH Sub I, LLC dba Internet Brands