I dont understand MS
#211
There's one where you set what functions the LEDs display, mine are the two spark channels and the middle is on if warmup enrichments are on. Forget what the setting is called, but is that the one's he's looking for Scott?
#216
output 3 and spark are the only ones in that menu, d15 has an IRQ trigger whatever that means, but none of the little menus have a "launch in" setting
Last edited by RedTurboMiata; 03-05-2012 at 09:37 AM.
#218
I think it just works with JS11 when launch is turned on, like i said it's been a while. That's the default launch input.
you need to figure out why it's not engaging. Make sure the parameters are setup correctly and you are triggering them.
try the TPS at like 5% just to test, make sure the clutch is pressed down all the way, and try it in gear and while in neutral. Also remember, TPS is in RAW, so you need to go by what you TPS calibration is...it's not in percent. So if your TPS calibration is 80ADC closed and 200ADC open, it needs to be atleast set above 80 to work.
turn variable off, set the retard ignition above to 2000RPM, set the timing to 5 degrees, hard limit at 2200 and test it out.
Be a do'er, not a little hand holder guy. If it only works when the shifter is in nuetral, you need to unplug the safety switch on the tranny.
you need to figure out why it's not engaging. Make sure the parameters are setup correctly and you are triggering them.
try the TPS at like 5% just to test, make sure the clutch is pressed down all the way, and try it in gear and while in neutral. Also remember, TPS is in RAW, so you need to go by what you TPS calibration is...it's not in percent. So if your TPS calibration is 80ADC closed and 200ADC open, it needs to be atleast set above 80 to work.
turn variable off, set the retard ignition above to 2000RPM, set the timing to 5 degrees, hard limit at 2200 and test it out.
Be a do'er, not a little hand holder guy. If it only works when the shifter is in nuetral, you need to unplug the safety switch on the tranny.
#219
as you said before the launch should notfiy whenever i can be enabled and its not going on in netural, clutch down, any combination of the above. while reving i should add. its on with all the above settings but my tps is at 21 so i set it to 30. nothing. could it be that my netrual saftey switch is bad and unpluging it will fix the problem?