Custom Harness
#21
will it work on that sort of wiring loom? I could see if working on something better like that weaved sleeve, but the split loom will collapse under the pressure needed to get the self fusing tape to really hold together.
#25
I think I used it on my cop harness actually. the coil connectors have a little barb-like fitting on them if I recall.. if you wrap the tape tight around that and loose around the loom, it'll stay put nicely.
mcmaster will have your ---- to you in a business day.
mcmaster will have your ---- to you in a business day.
#26
QUESTION...
If I have say a coolant temp sensor... and I have the coolant sensor wire running from the MS to it.. and the other is at a shared ground in the engine bay. Will that mess up the reading? Since it is normally grounded at the sensor ground off the MS?
So I have it like this..
MS-------CLT--------Chassis Ground
Stock is...
MS-------CLT--------Sensor GND off MS
For some reason I didn't really think about it until I was making the harness. What if I have the MS sensor GND wired to the chassis? ---- I'm dehydrated, hungry and tired. I'm sure I would normally know wtf to do.
If I have say a coolant temp sensor... and I have the coolant sensor wire running from the MS to it.. and the other is at a shared ground in the engine bay. Will that mess up the reading? Since it is normally grounded at the sensor ground off the MS?
So I have it like this..
MS-------CLT--------Chassis Ground
Stock is...
MS-------CLT--------Sensor GND off MS
For some reason I didn't really think about it until I was making the harness. What if I have the MS sensor GND wired to the chassis? ---- I'm dehydrated, hungry and tired. I'm sure I would normally know wtf to do.
#30
For a neater "package", just wrap the ends of the wires in-line, heat shrink down the wire. Solder the two wires together and then heat shrink the joint together. Much cleaner harness.
Also, stagger the joints so that the entire bundle does not have a huge bulge.
Just a suggestion,
Jeff
Also, stagger the joints so that the entire bundle does not have a huge bulge.
Just a suggestion,
Jeff