getting ready to drop motor by the subframe
#12
Then you are missing the obvious choice. You want to cut the front structure off and slide the engine out the hole. 10X easier than lifting it or dropping it. All you need is a sawz-all (or plasma cutter) and 20 minutes. I'd post a picture of the few times I've done it but you probably get the idea...
#14
Then you are missing the obvious choice. You want to cut the front structure off and slide the engine out the hole. 10X easier than lifting it or dropping it. All you need is a sawz-all (or plasma cutter) and 20 minutes. I'd post a picture of the few times I've done it but you probably get the idea...
Last edited by jared8783; 07-31-2011 at 11:12 PM.
#15
only body and interrior parts
this way when ever my car breaks down (only 74k on my 90) i will already have low mileage parts on hand
everything that is better about this car will go on my car
but im just gonna stick the enging and tranny in my garage and let it sit there for a few years or so idk and i would like to have a small turbo set up for it before i put it in
i dont gotta worry about short nose crank no more
this way when ever my car breaks down (only 74k on my 90) i will already have low mileage parts on hand
everything that is better about this car will go on my car
but im just gonna stick the enging and tranny in my garage and let it sit there for a few years or so idk and i would like to have a small turbo set up for it before i put it in
i dont gotta worry about short nose crank no more
#20
only interrior and exterrior parts.
the driver fender is bad and the driver door is not for sale
oh and i will sell the complete ac system
and i will sell the complete wiring harness and ecu
basically anything thats not drivetrain or i cant or dont want to use on my car
the driver fender is bad and the driver door is not for sale
oh and i will sell the complete ac system
and i will sell the complete wiring harness and ecu
basically anything thats not drivetrain or i cant or dont want to use on my car
Last edited by jared8783; 08-07-2011 at 09:13 AM.