I am currently replacing my single DIN 3 gauge setup (EGT, boost/vacuum, WB) with a double DIN 5 gauge panel. The panel is powder coated aluminum and consists of 2 pieces. The surround which fits into the dash and the main panel which overlays the first piece and is held in place with 4 setscrews. Makes getting to the rear of the panel a snap if ever needed. Check out their offerings here:

http://www.injoycarlife.com/radio-gauge-plates.php

No affiliation, just a satisfied user.

I am debating working on my dash/gauge setup tomorrow. Depends on if I get the S10 done early. If so I will do the diff and rear subframe.

those !NJOY stuff looks good. Just want to see pics of the NB one

Just a quick question. How do you guys run the wire for a wideband o2 sensor into the cabin?

There are a ton of holes in the trans tunnel to choose from.

anyone got a how to for wideband install?

From the good folks at Miata Turbo:

http://miataturbo.wikidot.com/wideband-install

that's exactly the wideband I have, thanks, I was getting confused with what all these wires were. This how to doesn't explain what the 2 wires with headphone jacks labeled "in" and "out" do.

For that go here:

http://www.innovatemotorsports.com/s...C-1_Manual.pdf

http://www.aliexpress.com/fm-store/2...eeShipCountry=

anyone wanna guinea pig knockoff defis? lol

I'm guessing you'll still need the defi controller to run these... but at <$20 per gauge...