99mx5's ARTech EFR build
#11
I made a support bracket for the oil pressure sender. The turbo oil line is Tee'd off the engine block at the sender. Since it hangs away from the block, I wanted to support it for when the engine shakes from hitting the rev limiter. I used steel fittings for all the lines except for the turbo oil drain line.
#14
I made small L brackets to support the intercooler. Shaving Seconds welded mounting tabs to the intercooler end caps and I made aluminum angle supports to mount it to the brackets on the frame. I was lucky that it cleared the AC parts and fit under the bumper.
I cut the intercooler charge pipes to route them and had them welded. The only couplers are at the ends of the pipes. The intercooler clears the AC evaporator and drier and fits in the bumper.
I cut the intercooler charge pipes to route them and had them welded. The only couplers are at the ends of the pipes. The intercooler clears the AC evaporator and drier and fits in the bumper.