My 2002 BEGI S4 GT2860RS - White and sexy.
#122
Awesome build! I enjoyed every page of it
Where did you find that transmission speed "calculator"?
You need a 3.9, IMO, with 310rwhp/290ftlbs you'll be going thru the gears rather quickly. Also great numbers, especially on a mustang dyno!
Where did you find that transmission speed "calculator"?
You need a 3.9, IMO, with 310rwhp/290ftlbs you'll be going thru the gears rather quickly. Also great numbers, especially on a mustang dyno!
#123
#124
When my old connecting rod went through the bottom of my oil pan, it took out my Power Steering rack with it. It cracked the rack in half and I didn't catch this until i noticed the entire under side of my engine was covered in power steering fluid.
Here is the old rack - Not supposed to see the actual shaft inside it and there is fluid all over the place.
Cleaned everything up like a bawse. Grinded the control arms and sub frame and then repainted it with protective enamel paint.
I while the car was in the air I pulled the bumpers and filled the emblem holes. The bumpers could have used a fresh respray anyways. I'll have these on the car tomorrow.
Here is the old rack - Not supposed to see the actual shaft inside it and there is fluid all over the place.
Cleaned everything up like a bawse. Grinded the control arms and sub frame and then repainted it with protective enamel paint.
I while the car was in the air I pulled the bumpers and filled the emblem holes. The bumpers could have used a fresh respray anyways. I'll have these on the car tomorrow.
#125
New toys I picked up last week.. I'm not a fan of my factory belts rubbing over the shoulder of my suede seat. Eventually it will wear and start to look like ish- So I grabbed the Street Tuner belts from Sparco. It's still a 4 point belt but it has a more daily-friendly-buckle instead of the turn buckle deal.
Notice the effect of extreme G force on my face.
Notice the effect of extreme G force on my face.
#129
push it further into the trans tunnel. Doesn't fit? hammer the living ---- out of the trans tunnel.
I seriously used a 4 lb sledge. Not that you need that big of a hammer, its just nice to have a nice large area to hit with.
I seriously used a 4 lb sledge. Not that you need that big of a hammer, its just nice to have a nice large area to hit with.